Annual average daily traffic (AADT) is the average number of vehicle passages per day at a road location over a reporting year. Read it as an annual measure of how much traffic uses that part of the road. For a specific hour or season, look for traffic counts that cover the time you care about. FHWA Traffic Monitoring Guide, Chapter 3

How a few days of counts become a yearly average

An agency can calculate AADT from a station that counts throughout the year or estimate it from a short count. Average daily traffic (ADT) in a count file can describe just the days that were observed. A short count taken on weekdays during a busy travel month can therefore have a different daily average from the annual estimate for the same site. FHWA Traffic Monitoring Guide, glossary FHWA Traffic Monitoring Guide, Chapter 3

Agencies use patterns from continuous stations to adjust short counts for differences by day of the week and month. They can also use time-of-day patterns to estimate a daily total from an observation shorter than a day. The length of the observation and how well the adjustment factors fit the site both affect the estimate. Even a permanent counter can miss data, so a long outage during a route’s busiest weeks can pull down a simple average of the days that remain. FHWA Traffic Monitoring Guide, Chapter 3

Which part of the road does the number cover?

Check the map segment, reporting year and direction before comparing two AADT values. In the federal Highway Performance Monitoring System, agencies report both directions together for two-way sections and the applicable direction for one-way roads and ramps. A parallel mainline and ramp can therefore have figures for different traffic streams even if their map labels are close together. Also check the year the underlying count was taken. Federal reporting calls for an AADT value representing the current data year, and some road classes are counted on a multiyear cycle. FHWA Highway Performance Monitoring System Field Manual, item 21

When to use vehicle miles traveled

Use vehicle miles traveled (VMT) when the question is how much distance vehicles covered across a network. FHWA’s Highway Statistics table VM-202 summarizes annual vehicle miles nationally by road class, with separate rural and urban columns. For example, a count of vehicles passing a point on a rural highway tells you the volume at that point. A VMT figure for all rural highways describes the distance vehicles covered across that road network. FHWA Highway Statistics, table VM-202 FHWA Traffic Monitoring Guide, Chapter 3